Fasten the accompanying PVC trims to the studs with screws, nails, glue or staples.
Select the first panel and remove the tongue on the left-side of the board and cut to length. Place the board onto the battens/wall into the trim with the front of the panel towards you and the groove-side to the right. Fasten the board on the groove-side by the end lip using screws, nails or staples, or apply glue at the back of the panel to fix it entirely to the battens.
Select the next panel, put the tongue in the groove of the previously fixed panel until you have a good fit, and fasten the board again on the groove side using the same method as before. Continue this step until you hit the end of the wall. Cut off remainders and use a PVC trim to finish off the installation.
Do not mount load bearing accessories directly onto Dumaplast panels, but drill holes through the panels directly into the battens or walls depending on the accessory, and use screws to fasten the accessories into the studs or walls.
Each Dumaplast PVC product can be cut or trimmed easily using a hand saw, table saw, portable circular saw, sabre saw or sharp utility knife. Caution - take appropriate precautions when using any cutting tools.
